Installation manual

TRINIX — Release Notes 23
Software Installation
Figure 16. The Firmware Management Screen
Some of the Status lights, in the Status column, will be red following an
installation using a Compact Flash card (
Figure 16). This indicates that the
software that is currently running in the module is different (or older) than
the software that was just installed. The new software should be activated
by following the instructions provided below.
Activating Software
1. Click the Activate button at the bottom of the page (Figure 16). The
Message from webpage dialog will then appear:
Figure 17. The Estimated Time Dialog
2. Click the OK button. The Broadlinx: Updating firmware status window
will then appear:
The installed version of
Broadlinx
Older firmware