Installation manual

22 TRINIX — Release Notes
Version 3.3.0
Figure 15. NR-33000 (Broadlinx board) Controls.
Using the Web Page
Navigate to the Broadlinx Web page to complete updating the firmware.
Note Do not press the Browser's Refresh button (or press F5 on your keyboard)
during the installation. A redrawing issue may occur with the 512x1024
routing switcher's Web page. If you do press the Refresh button, you must
reset the bottom half of the 512x1024 frame.
The Broadlinx Firmware Management page displays the following:
• The possible types of PC boards
• The version of the Broadlinx software that is presently associated
with each type of board that is installed
• The versions of top-level software packages that are present in the
Broadlinx board
• The compatibility Status of these software elements.
An example of this table is shown in the figure below (Figure 16 on
page 23).
When accessing this web page there may be a slight delay as the page is
gathering the latest information.
Reset button
Activate button
and "Active" LED
Flash module
e
j
ector button
NR board
left ejector lever
Flash module