Installation manual

TRINIX — Release Notes 21
Software Installation
Updating Systems with Two Broadlinx Boards
This section describes the steps for updating existing Broadlinx boards. The
Installation process uses the Broadlinx Firmware Management Web page.
These steps are described below.
Note Using Telnet or a Console session during an firmware update can cause the
update to fail.
Follow these steps to update all the boards within the frame (except an
active NR-33000 board):
1. Remove the Broadlinx board from the chassis and remove the existing
compact Flash card by pressing the Eject button (
Figure 15 on page 22).
Note For the Asymmetric frames, the NR-33000 (Broadlinx) board is turned side-
ways, so the Eject button is at the bottom.
For Encore controlled systems, the memory must be cleared by discon-
necting the battery terminal, leave it un-connected for couple of min-
utes, and then reconnect the battery (Figure 14).
Figure 14. Battery location on the NR-33000.
2. Insert the Compact Flash card into the slot on the Broadlinx board and
then insert the Broadlinx board into the frame. Broadlinx will then
inventory the boards that are in the frame.
071828316-BATTERY CONNECTION
Battery terminal location