Installation guide

26
Configuring the router
3 Enter the following settings, as appropriate:
C
ONFIGURING IP FILTERS
Filters are used to deny or allow LAN computers from accessing the Internet. The
router can be set up to deny access to internal computers by their IP or MAC
addresses. The router can also block users from accessing restricted Web sites.
To configure IP filters:
1 Access the Configuration menu by following the instructions in To access
the Web-based configuration utility: on page 13.
2 Click the
Advanced tab, then the Filters button. The Filters screen opens.
Field Description
Name The name referencing the special application.
Trigger Port The port used to trigger the application. It can be either a single port or a range
of ports.
Trigger Type The protocol used to trigger the special application.
Public Port The port number on the WAN side that will be used to access the application. You
can define a single port or a range of ports. You can use a comma to add multiple
ports or port ranges.
Public Type The protocol used for the special application.