Quick Setup Guide

Mounting plate
Quick-release plate
locking knob
Center column
locking screw
Package contents
• Tripod
• Carrying case
• Quick Setup Guide
Features
• 3-way pan head with slide quick release plate
• Smooth uid movement for cameras up to 11 lbs (5 kg)
• Center column converts to a monopod that extends
59.3 in. (150.6 cm)
• Independent legs spread with three angle adjustments
• Reversible tripod leg
# Item
1 Leveling bubble
2 Vertical tilt lock
knob
3 Vertical tilt lock
handle
4 Leg release button
5 Mounting plate
6 Quick-release plate
locking knob
7 Pan locking knob
8 Center column
locking screw
9 Center column/
monopod leg
10 Flip-lever leg locks
11 Rubber feet
Description
The quick release plate is level when the bubble
is in the center.
Adjusts vertical tilt up to 90 degrees.
Adjusts vertical tilt for head.
Lets you adjust the leg angle position
Holds your camera.
Secures the quick-release plate to the tripod.
Locks the tripod head so that it will not rotate
horizontally.
Locks the center column in place.
Provides quick height adjustment.
Locks the legs in place.
Provide a secure, non-slip footing for your tripod.
Setting up your tripod
1 Open the ip-lever leg locks on each leg.
2 Extend the leg sections from the top down (thickest section rst)
to reach the height you want.
3 Close the ip-lever leg locks on each leg.
Caution: Incorrectly securing a leg lock can cause the tripod leg to
retract unexpectedly and could result in damage to the tripod or to the
attached camera or camcorder.
4 Adjust the height of the center column by loosening the center
column locking screw, raising the center column to the height
you want, then tightening the locking screw.
5 To set the angle position of the legs, press the leg release buttons
and lift the tripod leg.
6 To remove the mounting plate, turn the quick-release plate
locking knob counter-clockwise to loosen it, then turn the
quick-release plate locking knob open, then lift the mounting
plate to remove it.
7 Align the bottom of your camera or camcorder with the
1/4" mounting screw, then secure your camera or camcorder to
the plate with the screw. The screw should be tight.
8 To attach the mounting plate to your tripod, loosen the
quick-release plate locking knob, then slide the plate onto the
tripod head. Tighten the quick-release plate locking knob.