Products Flat Panel Television User Manual

Understanding the basics
11
DX-32E150A11
If you selected Antenna or Cable, your TV automatically scans
for available channels in your area and stores the channel
information in the channel list. This may take several minutes.
While scanning, the TV displays a progress report.
– OR –
If you selected Cable/Satellite Box, the auto scan is not
necessary and the screen will ask you to select the correct input
source for your set top box. Press EXIT to close the menu.
Note: Channel scan can take up to 20+ minutes.
You can press EXIT at any time to stop the auto scan, but you will need to
run the auto scan again to create a channel list.
12 Select the corresponding video input source through the Source
List.
Understanding the basics
Turning your TV on or off
To turn your TV on or off (standby mode):
1 Plug the power cord into an AC power outlet.
2 Press (power). Your TV turns on.
3 Press again to turn off your TV. When you turn off your TV, it
goes into standby mode.
Warning: When your TV is in standby mode, it is still receiving power. To
completely disconnect power, unplug the power cord.
Note: If your TV does not receive an input signal for several minutes, it
automatically goes into standby mode.
Selecting the video input source
To select the video input source:
1 Turn on your TV, then press the INPUT key on the remote, or the
INPUT button on the TV. The Source List menu opens.
2 Press or to highlight the video source, then press ENTER.
You can also press TV to switch to TV mode.
Selecting a channel
To select a channel:
• Press CH+ or CH- to go to the next or previous channel on the
memorized channel list.
• Press the number buttons to enter the analog or digital (main)
channel number you want, then wait for the channel to change,
or press ENTER to change the channel immediately.
• To select a digital sub-channel, press the number buttons to
select the main digital channel, then press the dot (.) button
to select the sub-channel. Wait for the channel to change, or
press ENTER to change the channel immediately.
Note: Button presses must be within three seconds of each other.
• Press RECALL to go to the last channel viewed.
Adjusting the volume
To adjust the volume:
• Press VOL+ or VOL– to increase or decrease the volume.
• Press MUTE to temporarily turn off all sound. Press MUTE again
to restore the sound.
Displaying additional information
To display additional information:
•Press INFO to show an information banner. The information
banner shows current program information such as resolution.
• Digital mode information—Displays program name, time,
channel number, channel label, TV rating, resolution, and
current signal strength, and audio information.
• Analog mode information—Displays channel number,
audio information, TV rating, resolution, channel label, and
current signal strength.
• Press GUIDE to show the digital program guide, which may show
a list of available programs, program times, and program
summaries, depending on the information provided by the
broadcaster.
On-screen menu overview
PICTURE menu
AUDIO menu
Source List
HDMI1
VGA
AV
TV
HDMI2
PICTURE AUDIO CHANNELS SETTINGS
Mode
Advanced Video
Sharpness
Tint
Color
Contrast
Brightness
Energy Savings
6
0
70
57
48
PICTURE AUDIO CHANNELS SETTINGS
Sound Mode
Audio Language
MTS/SAP
Surround
Balance
Bass
Treble
0
40
50
Standard
On
STEREO
English
Digital Audio/SPDIF PCM
DX-32E150A11_10-1312.book Page 11 Monday, December 13, 2010 1:36 PM