Safety Data Sheet, Part 2

ManualsBrandsDynesic ManualsChemicals & CompoundsSILVERSHIELD Indoor/Outdoor Epoxy Paint with Silver Flake (1 Gallon Kit)

SDS Revised March 2017

Complies with OSHA HCS Standards

Section 1: Identification

Safety Data Sheet (Complies with OSHA)

Product Identifier SILVERSHIELD 5000X Part B

Other Means of Identification: SILVESHIELD 5000X–1G, 5000X-Q

Recommended Use Not Available

Recommended Restrictions None known

Manufacturer/Importer/Supplier/Distributor information

Company Name: Dynesic Technologies, Inc.

15230 Surveyor Blvd., Addison, TX 75001

Phone: 972-692-0962

After hours telephone number Phone: 972-692-0962

Website www.dynesic.com

Email sphillips@dynesic.com

Emergency 24 hour telephone CHEMTREC: North America 1-800-424-9300

International 1-800-527-3887

Operation hours information 7:00 a.m. to 7:00 p.m.

Section 2: Hazard(s) Identification

Physical hazards Not classified

Health hazards Skin corrosion/irritation Category 1

Eye damage/eye irritation Category 1

Sensitization, skin Category 1

Environmental hazards Not classified

OSHA defined hazards Not classified

Label elements

Signal word Danger

Hazard statement Causes severe skin burns and eye damage. May cause

an allergic skin reaction. Causes serious eye damage.

Precautionary statement

Prevention Do not breathe mist or vapor. Wash thoroughly after

handling. Contaminated work clothing must not be

allowed out of the workplace. Wear protective gloves/

protective clothing/eye protection/face protection.

Response IF SWALLOWED: Rinse mouth. Do NOT induce vomiting.

IF ON SKIN (or hair): Take off immediately all

contaminated clothing. Rinse skin with water/shower.

Wash contaminated clothing before reuse. IF INHALED:

Summary of content (11 pages)

PAGE 1
SDS Revised March 2017 Complies with OSHA HCS Standards 1. Safety Data Sheet (Complies with OSHA) Section 1: Identification Product Identifier SILVERSHIELD 5000X Part B Other Means of Identification: SILVESHIELD 5000X–1G, 5000X-Q Recommended Use Not Available Recommended Restrictions None known Manufacturer/Importer/Supplier/Distributor information Company Name: Dynesic Technologies, Inc. 15230 Surveyor Blvd.
PAGE 2
SDS Complies with OSHA HCS Standards 2. Remove person to fresh air and keep comfortable for breathing. Immediately call a poison center/doctor. Specific treatment see Section 4 of this SDS. IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. IF ON SKIN: Wash with plenty of soap and water. If skin irritation or rash occurs: Get medical advice/attention. Storage Disposal Store locked up.
PAGE 3
SDS Complies with OSHA HCS Standards 3. medical device. Most important symptoms/effects, acute and delayed Burning pain and severe corrosive skin damage. Causes serious eye damage. Symptoms may include stinging, tearing, redness, swelling, and blurred vision. Permanent eye damage including blindness could result. May cause an allergic skin reaction. Dermatitis. Rash. Indication of immediate medical attention and special treatment needed Provide general supportive measures and treat symptomatically.
PAGE 4
SDS Complies with OSHA HCS Standards 4. Methods and materials for containment and cleaning up Extinguish all flames in the vicinity. This product is miscible in water. . Large Spills: Stop the flow of material, if this is without risk. Dike the spilled material, where this is possible. Cover with plastic sheet to prevent spreading. Absorb in vermiculite, dry sand or earth and place into containers. Following product recovery, flush area with water. Small Spills: Wipe up with absorbent material (e.g.
PAGE 5
SDS Complies with OSHA HCS Standards 5. US - Tennessee OELs: Skin designation [3-(aminoethyl)phenyl]methanamine (CAS 1477-55-0) Can be absorbed through the skin. US ACGIH Threshold Limit Values: Skin designation [3-(aminoethyl)phenyl]methanamine (CAS 1477-55-0) Can be absorbed through the skin. US NIOSH Pocket Guide to Chemical Hazards: Skin designation [3-(aminoethyl)phenyl]methanamine (CAS 1477-55-0) Can be absorbed through the skin.
PAGE 6
SDS Complies with OSHA HCS Standards 6. Melting point/freezing point Not available Initial boiling point and boiling range 212 °F (>260 °C) Flash point > 200 °F (> 93.
PAGE 7
SDS Complies with OSHA HCS Standards 7. Acute toxicity Components Species Test Results BENZYL ALCOHOL (CAS 100-51-6) Acute Dermal LD50 Rabbit 2000 mg/kg Oral LD50 Rat 1230 - 3100 mg/kg * Estimates for product may be based on additional component data not shown. Skin corrosion/irritation Irritating and may cause redness and pain. Serious eye damage/eye irritation Causes severe eye burns. Respiratory or skin sensitization Respiratory sensitization Not available. Skin sensitization Causes skin burns.
PAGE 8
SDS Complies with OSHA HCS Standards 8. Product Species Test Results SP2XXX Series Part B Coating and Lining (All Colors) (CAS Mixture) Aquatic Crustacea EC50 Daphnia 57.2773 mg/l, 48 hours estimated Fish LC50 Fish 416.2358 mg/l, 96 hours estimated Components Species Test Results 3-AMINOMETHYL-3,5,5-TRIMETHYLCYCLOHEXYLAMINE (CAS 2855-13-2) Aquatic Crustacea EC50 Daphnia magna 14.6 - 21.
PAGE 9
SDS Complies with OSHA HCS Standards 9. Special precautions for user Special provisions Packaging exceptions Packaging non bulk Packaging bulk IATA UN number UN proper shipping name Transport hazard class(es) Class Subsidiary risk Packing group Environmental hazards ERG Code Special precautions for use Passenger and cargo aircraft Cargo aircraft only Not available IB3, T7, TP1, TP28 154 203 241 UN number UN proper shipping name UN2735 AMINES, LIQUID, CORROSIVE, N.O.S.
PAGE 10
SDS Complies with OSHA HCS Standards 10. Section 15: Regulatory information US federal regulations This product is a "Hazardous Chemical" as defined by the OSHA Hazard Communication Standard, 29 CFR 1910.1200. TSCA Inventory List. TSCA Section 12(b) Export Notification (40 CFR 707, Subpt. D) Not regulated CERCLA Hazardous Substance List (40 CFR 302.4) Not listed US. OSHA Specifically Regulated Substances (29 CFR 1910.
PAGE 11
SDS Complies with OSHA HCS Standards 11. administered by the governing country(s) A "No" indicates that one or more components of the product are not listed or exempt from listing on the inventory administered by the governing country(s).