Safety Data Sheet, Part 1

ManualsBrandsDynesic ManualsChemicals & CompoundsSILVERSHIELD Indoor/Outdoor Epoxy Paint with Silver Flake (1 Gallon Kit)

SDS Revised March 2017

Complies with OSHA HCS Standards

Section 1: Identification

Safety Data Sheet (Complies with OSHA)

Product Identifier SILVERSHIELD 5000X Part A

Other Means of Identification: SILVESHIELD (5000X–1G, 5000X-Q

Recommended Use Not Available

Recommended Restrictions None known

Manufacturer/Importer/Supplier/Distributor information

Company Name: Dynesic Technologies, Inc.

15230 Surveyor Blvd., Addison, TX 75001

Phone: 972-692-0962

After hours telephone number Phone: 972-692-0962

Website www.dynesic.com

Email sphillips@dynesic.com

Emergency 24 hour telephone CHEMTREC: North America 1-800-424-9300

International 1-800-527-3887

Operation hours information 7:00 a.m. to 7:00 p.m.

Section 2: Hazard(s) Identification

Physical hazards Not Classified

Health hazards Skin corrosion/irritation Category 2

Eye damage/eye irritation Category 2B

Sensitization, skin Category 1

Carcinogenicity Category 1

Environmental hazards Not classified

OSHA defined hazards Not classified

Label elements

Signal word Danger

Hazard statement May cause cancer. Causes skin irritation. Causes eye

irritation.

Precautionary statement

Prevention

Obtain special instructions before use. Do not handle

until all safety precautions have been read and under

stood. Avoid breathing dust/fume/gas/mist/vapors/

spray. Wash thoroughly after handling. Contaminated

work clothing must not be allowed out of the work

place. Wear protective gloves/protective clothing/eye

protection/face protection.

Summary of content (10 pages)

PAGE 1
SDS Revised March 2017 Complies with OSHA HCS Standards 1. Safety Data Sheet (Complies with OSHA) Section 1: Identification Product Identifier SILVERSHIELD 5000X Part A Other Means of Identification: SILVESHIELD (5000X–1G, 5000X-Q Recommended Use Not Available Recommended Restrictions None known Manufacturer/Importer/Supplier/Distributor information Company Name: Dynesic Technologies, Inc. 15230 Surveyor Blvd.
PAGE 2
SDS Complies with OSHA HCS Standards 2. Response Specific treatment see Section 4 of this SDS. IF ON SKIN: Wash with plenty of soap and water. IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If skin irritation or rash occurs: Get medical advice/attention. If eye irritation persists: Get medical advice/attention. Take off contaminated clothing and wash before reuse.
PAGE 3
SDS Complies with OSHA HCS Standards 3. Section 5: Fire-Fighting Measures Suitable extinguishing media Water fog. Foam. Dry chemical powder. Carbon dioxide (CO2). Unsuitable extinguishing media Do not use water jet as an extinguisher, as this will spread the fire. Specific hazards arising from the chemical During fire, gases hazardous to health may be formed.
PAGE 4
SDS Complies with OSHA HCS Standards 4. Section 8: Exposure Controls/Personal Protection Occupational exposure limits US. OSHA Table Z-1 Limits for Air Contaminants (29 CFR 1910.1000) Components Type Value QUARTZ (CAS 14808-60-7) TWA 0.3 mg/m3 Total dust US. ACGIH Threshold Limit Values Components Type Value STEL TWA TWA 100 ppm 50 ppm 0.025 mg/m3 Respiratory fraction 1-METHOXYPROPAN-2-OL (CAS 107-98-2) QUARTZ (CAS 14808-60-7) US.
PAGE 5
SDS Complies with OSHA HCS Standards 5. Section 9:Exposure PhysicalControls/Personal and Chemical Properties Section8: Protection Appearance Liquid Physical state Liquid Form Viscous Liquid Color Silver Odor Slight Odor threshold Not available pH Not available Melting point/freezing point Not available Initial boiling point and boiling range >500 °F (>260 °C) Flash point > 200 °F (> 104.
PAGE 6
SDS Complies with OSHA HCS Standards 6. SectionExposure 11: Toxicological Information Section8: Controls/Personal Protection Information on likely routes of exposure Ingestion Expected to be a low ingestion hazard. Inhalation May be harmful if inhaled. Skin contact Causes skin irritation. Eye contact Causes eye irritation. Symptoms related to the physical, chemical and toxicological characteristics Direct contact with eyes may cause temporary irritation.
PAGE 7
SDS Complies with OSHA HCS Standards 7. Section 12: Ecological Information Section8: Exposure Controls/Personal Protection Ecotoxicity Product 5000X Part A Aquatic Crustacea EC50 Fish LC50 The product contains a substance which is toxic to aquatic organisms Species Test Results Daphnia Fish 0.8463 mg/l, 48 hours estimated 2.8319 mg/l, 96 hours estimated * Estimates for product may be based on additional component data not shown.
PAGE 8
SDS Complies with OSHA HCS Standards 8. Environmental hazard class(es) Marine Pollutant Yes EmS F-A, S-F Special precautions for Not available user Transport in bulk according to Annex II of MARPOL 73/78 and the IBC Code IMDG Marine Pollutant General information DOT Regulated Marine Pollutant. IMDG Regulated Marine Pollutant. Section 15: Regulatory information US federal regulations This product is a "Hazardous Chemical" as defined by the OSHA Hazard Communication Standard, 29 CFR 1910.1200.
PAGE 9
SDS Complies with OSHA HCS Standards 9. SARA 311/312 No Hazardous chemical SARA 313 (TRI reporting) Not regulated Other federal regulations Clean Air Act (CAA) Section 112 Hazardous Air Pollutants (HAPs) List Not regulated Clean Air Act (CAA) Section 112(r) Accidental Release Prevention (40 CFR 68.130) Not regulated Safe Drinking Water Act Not regulated US state regulations WARNING: This product contains a chemical known to the State of California to cause birth defects or other reproductive harm.
PAGE 10
SDS Complies with OSHA HCS Standards 10. Disclaimer The information provided in this Safety Data Sheet is correct to the best of our knowledge, information and belief at the date of its publication. The information given is designed only as a guidance for safe handling, use, processing, storage, transportation, disposal and release and is not to be considered a warranty or quality specification.