Operation Manual

103
6.3.3 Driving time management
To calculate a better arrival time, it is necessary to include the waiting or loading times spent
at each waypoint. Driving timers allow you to be warned when you need a rest or you have
driven enough for the day. You have the following options:
Button Description
Turn this switch on to be able to set the waiting time for all waypoints
of the route. This way the arrival time calculation can take into account
the idle times at intermediate destinations. In addition, time dependent
restrictions and statistical traffic information can also be considered for
the whole route.
Set up and use countdown timers to monitor the continuous and daily
driving times as described on page 84.
6.3.4 Traffic settings
The recommended route is not always the same between two points. Whenever suitable data
exists, traffic information can be taken into account in the route calculation.
Button Description
Use this switch to enable or disable historical traffic data and traffic
patterns. This locally stored information can be very useful in normal
circumstances but for example on public holidays it may be better to
turn off in order not to take into account normal weekday traffic jams.
Use this switch to enable or disable the TMC receiver that can receive
real-time traffic information. The rest of the buttons below are all
related to the TMC function and are available only if the receiver is
enabled.
Use this switch to enable or disable receiving real-time traffic
information online. The rest of the buttons below are all related to this
real-time information and are available only if receiving is enabled.
You can also define whether to receive online traffic via the 3G
network or only when connected to a WiFi network.
This setting determines how iGO primo uses the received real-time
traffic information in route calculation. When calculating a new route,
or when recalculation becomes necessary based on the received
Traffic events, iGO primo avoids traffic events if it makes sense.
You can also set the minimum delay that triggers route recalculation,
and you can instruct the application if you want to confirm every
recalculation.
Tap this button to open the list of traffic event types, and select which
events to take into account in route calculation.