User's Manual
5
2.2 Mains and power connections
Your Dynaudio Music speaker requires connection to mains power.
Use the mains cable supplied with the speaker. Music 1 is additionally
supplied with an external power supply.
Music 1 and Music 3 incorporate an internal rechargeable battery that
enables them to be used while disconnected from mains power. The
battery will charge while mains power is connected.
Music 1 and Music 3 battery level is displayed by the Dynaudio Music
app but can also be established by pressing the Standby button
when the unit is switched-on and unplugged from mains power. The
volume indicator array will illuminate for a few seconds. To indicate a
fully charged battery all the indicators will illuminate. To indicate 50%
charge half the indicators will illuminate. When the battery charge falls
below 3% the rst indicator will ash slowly and the volume level will
reduce. When the battery level falls to 1% the speaker will switch off.
In normal use Music 1 and Music 3 battery life is eight to ten hours
following a full charge.
Note: Music 1 and Music 3 are shipped with a battery charge level of
between 70% and 80%.
Note: Dynaudio Music speaker models have two stand-by modes:
Network Standby and Deep Standby. In Network Standby mode, Wi-Fi,
Bluetooth, remote control and amplier functions remain active to enable
the speaker to play in response to app and remote handset commands
or a wired input signal. In Deep Standby mode all functions are disabled
to save power.
The speaker can only be woken from Deep Standby mode by
pressing a button or, in the case of Music 5 and Music 7 by triggering
the proximity sensor. Network Sleep mode is indicated by the rst
volume indicator illuminated red.
2.3 Switching-on and Standby Mode
To switch-on a Music 1 or Music 3 press any one of the on body
buttons.
Music 5 and Music 7 incorporate proximity sensing so to switch-on,
simply bring your hand close to the top panel.
Your Dynaudio Music speaker will switch on automatically from
standby in response to a Wi-Fi or Bluetooth stream, a USB
connection, or an audio signal present on one its wired inputs.
All Dynaudio Music speaker models will switch to Standby mode after
a period on inactivity. The auto-standby period can be specied in the
Dynaudio Music app. Music 1 and Music 3 can be switched off by
pressing and holding the Standby button. Music 5 and Music 7 cannot
be switched manually into Standby mode or fully switched off. They
can only be switched off fully by disconnection from mains power.