Specifications

18 Dynaudio Owners Manual
Installation
Installing IC 17
Installing the IC 17 ceiling loudspeaker is very easy. No additional installation aids are
needed.
Installation steps
 For wall cut out dimensions see page 20.
1. Remove the grille from the loudspeaker (the grille is simply clipped into place).
2. Connect the loudspeaker cables coming from the amplifier to the terminals of the
frequency crossover at the loudspeaker:
a. Connect the positive lead to the red marked positive terminal (+). The positive lead
usually has an additional identification label.
b. Connect the negative lead to the black marked negative terminal (–).
3. Mount the loudspeaker into the ceiling cut out.
4. Tighten the four screws crosswise until the loudspeakers is properly secured.
Setting up the loudspeaker
The tweeter sound level can be adjusted in three steps by means of a level switch
accessible from the speaker front. This allows you to adapt the IC 17 ceiling loudspeaker
to various acoustic environments.
✓ The grille is un-mounted.
5. Set the level switch at the desired level.
6. Clip the grille onto the speaker frame.