Specifications

ManualsBrandsDynaudio ManualsComputer equipmentIP 17

Installation Products

Contents

Introduction .................................................................................................................... 1

Dear Music Lover,...................................................................................................... 1

About this guide............................................................................................................. 2

General safety instructions........................................................................................... 3

Unpacking....................................................................................................................... 4

Installation recommendations ...................................................................................... 6

Positioning ................................................................................................................. 7

Foam piece for sound damping and optimization ...................................................... 8

Re-painting ..................................................................................................................... 9

Installation .................................................................................................................... 10

Checking the installation point ................................................................................. 10

Installing IW 17, IP 17 and IP 24 ............................................................................. 10

Installing IC 17 ......................................................................................................... 18

Running-in, Care & Maintenance................................................................................ 21

Running-in the loudspeakers ................................................................................... 21

Power rating............................................................................................................. 21

Care & Maintenance ................................................................................................ 22

Cleaning the loudspeakers ...................................................................................... 22

Warranty .................................................................................................................. 22

Technical specifications.............................................................................................. 23

Summary of content (28 pages)

PAGE 1
Contents Contents Introduction .................................................................................................................... 1 Dear Music Lover,...................................................................................................... 1 About this guide............................................................................................................. 2 General safety instructions....................................................................................
PAGE 2
PAGE 3
Introduction Introduction Dear Music Lover, Thank you for your decision to acquire a Dynaudio installation product. The loudspeakers of the Installation Product series feature the advanced Dynaudio technology, resulting in music reproduction at a very high level, making many familiar recordings a new listening experience altogether.
PAGE 4
About this guide About this guide Used expressions and symbols In this operating manual following expressions and symbols are used: The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product. CAUTION Note 2 Indicates (in combination with a safety sign) a potentially hazardous situation which could result in minor or moderate injury or damage to equipment.
PAGE 5
General safety instructions General safety instructions CAUTION High sound levels Listening to high sound pressure levels over a longer period of time may harm your hearing.  To avoid auditory effect do not listen to high sound levels over a longer period of time. CAUTION Damage of structural fire protection The cut out for an in-ceiling or in-wall speaker installation could damage the fire protection elements of a building.
PAGE 6
Unpacking Unpacking 1. Fold the top carton flaps back and carefully remove the contents. We suggest that you keep the entire packaging and all contents until the installation is complete. 2. Check the contents; see next page. 3. Remove the speaker from the plastic bag. IP series only: 4. Carefully remove the grille by lifting both ends of the red foil at the same time. 5.
PAGE 7
Unpacking 1 2 3 + 0 - 6a 4 5 7 8a 6b 8b 9 10 11 12 POSITIONING AND MOUNTING TEMPLATE FOR MODEL IC 17 Installation Products 5
PAGE 8
Installation recommendations Installation recommendations The Dynaudio IW/IP/IC models are designed to operate satisfactorily in a wide range of cavity volumes. Ideally these cavity volumes are: Model Cavity volume IW 17 > 15 liter (0.53 ft3) IP 17 > 15 liter (0.53 ft3) IP 24 > 30 liter (1.1 ft3) IC 17 > 15 liter (0.53 ft3) Avoid installing the speakers in the same cavity as any ducts, as this may result in excessive rattle.
PAGE 9
Installation recommendations Positioning Following explanations help you to find the right installation location: • The distance between each loudspeaker and your listening position should be the same. • The closer the listening position is in relation to the loudspeakers, the closer the speakers can be positioned to each other. • If the speakers are positioned too close to each other, the stereo image will not seem realistic; if that distance is too wide, the image may leave an acoustic hole in the middle.
PAGE 10
Installation recommendations Foam piece for sound damping and optimization The sound quality of any installation loudspeaker system without a cabinet enclosure is strongly influenced by the rigidity of the wall or ceiling and the damping of the internal wall cavity.  Note the following tips to improve the sound quality of your speaker installation: • A foam piece is supplied to damp the area behind the drive units.
PAGE 11
Re-painting Re-painting The frames and the grilles of the IW, IP and IC loudspeakers are painted in a white semimatte (RAL 9003) finish. Frames and grilles may also be re-painted, and are ready to be refinished to match your own interior décor scheme. CAUTION Improper painting Do not paint the baffle (of the IP series loudspeakers) and the drive units. Paint on these parts may worsen the sound quality or even destroy the product.  Protected the baffle and drive units e.g.
PAGE 12
Installation Installation Checking the installation point WARNING Pipe work, air conditioning, power cabling Damaging existing in-wall installations may cause severe injury or death.  Before producing the wall or ceiling cut-out, be sure that no conflict with other in-wall installations will occur (pipe work, air conditioning, power cabling, etc.).
PAGE 13
Installation Installation steps (IP 17 and IP 24 only) (For descriptions of the steps see next page.) 1. 2. 3. 4.
PAGE 14
Installation  Produce the cut-out (for wall cut-out dimensions see page 16 and page 17). WARNING: Notice and follow the safety warnings about existing in-wall installations on page 10! Installing IP 17 and IP 24  In case you have already unpacked your loudspeakers, continue with step 4, otherwise start with step 1: 1. Carefully remove front grille by lifting up strips. 2. Un-tighten the screws (Torx 20 bit): IP 17: 6, IP 24: 10 Place the screws into the accessory pack for later use. 3.
PAGE 15
Installation 5a. 6. 5b. IP 17 / IP 24 min. (I) max. min. 0 mm (0") max. 40 mm (1.6") 5c. min. IW 17 min. 36 mm (1.4") max. 65 mm (2.6") (II) max.
PAGE 16
Installation 7. Make sure that the amplifier power is switched off. Connect the speaker terminal to the amplifier. 8. Put the foam on the rear side of the woofer in its correct position. 9. Position the baffle with top first. Make sure not to jam or damage the speaker wire. 10. To lock the speaker unit into position tighten the screws, which you have unscrewed at the beginning (see step 2). 11.Insert the grille by pressing it carefully into the gap between the frame and baffle.
PAGE 17
Installation 7. 8. Crossover 9. Amplifier IP 17 / IP 10. 11.
PAGE 18
Installation Dimensions IW 17 / IP 17 Housing (IW 17) / Mounting frame (IP 17) a b Height: Width: 289/325 mm 195/225 mm (11.38/12.80") (7.68/8.86") Cut out (IW 17/IP 17) c d Height: Width 269,5/295 mm 175,5/194 mm (10.61/11.61") (6.91/7.64") Grille (IW 17/IP 17) e f Height: Width: 260/285 mm 163,5/185 mm (10.24/11.22") (6.44/7.28") Minimum depth required (IW 17/IP 17) g Depth: 92/92 mm (3.62/3.
PAGE 19
Installation Dimensions IP 24 Aluminium mounting frame a b Height: Width: 385 mm 286 mm (15.15") (11.25") Cut out c d Height: Width: 351 mm 252 mm (13.82") (9.92") Grille e f Height: Width: 343 mm 244 mm (13.50") (9.60") Minimum depth required g Depth: 92 mm (3.
PAGE 20
Installation Installing IC 17 Installing the IC 17 ceiling loudspeaker is very easy. No additional installation aids are needed. Installation steps  For wall cut out dimensions see page 20. 1. Remove the grille from the loudspeaker (the grille is simply clipped into place). 2. Connect the loudspeaker cables coming from the amplifier to the terminals of the frequency crossover at the loudspeaker: a. Connect the positive lead to the red marked positive terminal (+).
PAGE 21
Installation 1. 2. 3. Crossover _ 4. Amplifier + 5. 0 6.
PAGE 22
Installation Dimensions IC 17 Dimensions (Ø) a 236 mm (9.3") Cut out (Ø) b 218 mm (8.6") Minimum depth required c 109 mm (4.
PAGE 23
Running-in, Care & Maintenance Running-in, Care & Maintenance Running-in the loudspeakers The moving parts of a newly manufactured loudspeaker have been acoustically checked after production, but nevertheless are not as flexible as they need to be for optimum results to be realized. The higher the quality of any driver system, the more demanding the loudspeaker will be regarding time for running-in the system.
PAGE 24
Running-in, Care & Maintenance Care & Maintenance Dynaudio loudspeakers require no special treatment apart from the kind of careful handling you would normally apply to any high tech product in your home. CAUTION Aggressive cleaning fluids All-in-one cleaning materials, aggressive cleaning fluids or special furniture polishes may damage the cabinet surface or other speaker parts.  Use a soft dry or slightly damp cloth when cleaning the cabinet and other plain parts.
PAGE 25
Technical specifications Technical specifications IW 17 IP 17 IP 24 IC 17 2 way 2 way 2 way 2 way axial Mid/woofer 165 mm (6.5"), cone 165 mm (6.5"), cone 240 mm (10"), cone 165 mm (6.5"), cone Tweeter 21 mm (3/4"), dome 28 mm (1.1"), dome 28 mm (1.1"), dome 21 mm (3/4"), dome Sound level adjust (Tweeter) ±2 dB ±1.5 dB ±1.5 dB ±2 dB Sensitivity (2.
PAGE 26
PAGE 27
PAGE 28