Technical information

Owners Manual 9
Controls and connections
➐
SUB I/O
• LFE/Slave in: input for LFE signal from processor/receiver. Note that the signal
must be a true LFE signal or already have been filtered by the processor/receiver,
as SUB Lowpass does not have an effect in combination with the LFE input.
• LFE/to Slave: output to next subwoofer if installed.
➑
SAT/SUB Input
Input for full bandwidth signal from processor/receiver. This signal will be processed
according to the SAT Highpass setting and provided at the
SAT Output connection for satellite speakers to be connected.
➒
SAT Output
Output for satellite speakers to be connected. This signal is processed according to
the SAT Highpass setting.
➓
SAT Highpass
Allows cutting off low frequencies of the signal provided at the SAT Output.
• Flat: signal is not processed
• 60: cut-off frequency at 60 Hz
• 80: cut-off frequency at 80 Hz
➐
➑
➒
➓