Technical information

6 Dynaudio Sub 250

BEFORE OPERATION

Unpacking

To find the suitable position for the Sub 250 in your listening room, please read the

chapter “Positioning the subwoofer” on page 20.

To unpack the subwoofer

1. Unpack the subwoofer on a clean, even and soft area; floor carpeting is very suitable.

2. The packaging should be opened from the top. Remove all accessories that come

packed with the subwoofer (such as AC power cord and grille). Do not remove the top

part of the protective material.

3. With the protective material still in place but with accessories removed, carefully tilt

the packaging on its side and tilt again to turn it upside-down. Ensure that no part of

the top-cover is obstructing the opening at the top.

4. The outer packaging can now be lifted away from the subwoofer itself. Remove the

protective material that now is on top. Through the polyethylene bag you can now see

the underside of the subwoofer.

5. Open the plastic bag and remove such from around the base of the subwoofer.

6. Again, carefully tilt the subwoofer on its side and again to turn it onto its feet. Note that

the top part of the protective material will now come off easily so ensure that the

subwoofer does not drop or slide away in the process.

Check that the contents are complete

• Subwoofer: The factory-set power requirements (refer to label on rear of subwoofer)

should correspond for the region where the subwoofer was purchased. Refer also to

chapter “Important Safety Instructions” on page 2.

• Front baffle grille

• AC mains lead. The supplied lead should be suitable for the region where the

subwoofer was purchased.

• Owners Manual