User Manual

BM5 mkIII User manual

Setup and Operation

Overview – rear panel

Correct setup and connections is essential to achieve optimal performance from your monitors. Please follo

Power On/Off switch

AC power Input

Balanced analog input (XLR)

Unbalanced analog input (RCA)

Power Mode switch

Remote

Filter switches

High Pass

LF – Low filter setting

–

PAGE 1
Setup and Operation BM5 mkIII User manual Overview – rear panel Correct setup and connections is essential to achieve optimal performance from your monitors.
PAGE 2
Setting up 1/2. Power on/off switch / AC power in Before switching on, make sure Mains Voltage matches your area’s mains voltage specification. 3. Balanced analog input Audio Input is via a female XLR connector. The input is electronically balanced with the following connectio 4. Unbalanced analog input (RCA) Unbalanced Input via RCA. If your audio source doesn’t have a balanced output, use the RCA input connecti For best results always use only good quality screened cables and connectors.
PAGE 3
HF This switch controls the Treble level and it is used to match the high end of the monitor to your other electr HP This switch sets the lower cut-off frequency of the monitor. It is used to match the monitor to a subwoofer. 8. Level trim Use this switch to match the sensitivity of the BM5 mkIII monitor to your source. High-output Source If your source has a high output, set switch to the -10 position to reduce sensitivity by 10 dB.