Specifications

AIR Control software
Dynaudio Professional AIR reference manual – 2014-08-28 78
Selecting monitors
for conguration
►
Please refer to the section “AIR setups” on page
8 of this manual to nd the setup you want to
use.
►
Position and connect your monitors exactly as
described in the section for this setup.
After you have done this, you can use AIR Control
software to access each connected monitor and
congure its settings.
Selecting a monitor for conguration
Each detected monitor in an AIR system is represented
by a “tab” on top of the AIR Control software window.
Fig. 47: AIR Control software window top bar – two
monitors connected and detected. The left monitor
(“AIR6 L Front”) is selected for editing its settings.
Select the monitor you want to set up by clicking its tab
and congure it as described on the following pages. All
settings are applied immediately.