Specifications

AIR Menu structure and parameters
Dynaudio Professional AIR reference manual – 2014-08-28 38
Conguring bass
management
Bass management is available for the following setups:
►
Standard Stereo with 1 subwoofer
►
Standard Stereo with 2 subwoofer
►
5.1 Analog
►
5.3 Analog
►
6.1 Analog
►
6.1 Digital – at 192 kHz
►
5.3 Digital
►
5.1 Digital/6 Master
►
5.1 Digital – at 192 kHz
Notes on bass management
►
Satellite monitors use 2nd order highpass lters
to attenuate frequencies below the set crossover
frequency.
►
Subwoofers use 4th order lowpass lters to attenu-
ate frequencies above the set crossover frequency.
Conguring bass management
►
From the home screen, press the ENTER key.
“Bass Management” is displayed.
►
Press the ENTER key again.
“*Select Mode” is displayed.
►
Select the desired mode using the UP and DOWN
keys.
►
After setting the desired mode, press the EXIT key
to close the menu.
Bass management modes and crossover frequencies
Displayed name Bass management mode name Satellite
lter
Sub 4th
order
Sub 2nd
order
LFE = Sub
Off (No bass management; only the LFE
channel is distributed to the sub.)
X-Over 50 Hz X-Over 50 Hz 50 Hz 50 Hz 50 Hz No
X-Over 80 Hz X-Over 80 Hz 80 Hz 80 Hz 80 Hz No
Ext. 50 Hz Extension 50 Hz Off 50 Hz 50 Hz No
Ext. 80 Hz Extension 80 Hz Off 80 Hz 80 Hz No
THX 80 Hz THX Simulation 80 Hz 80 Hz 80 Hz Off Yes
SC 120 Hz Small Consumer 120 Hz * 120 Hz 120 Hz 80 Hz Yes
Note that the modes “Extension 50” and “Extension 80
Hz” use no bass management on satellite speaker, thus
playing full range.
Bass management and AIR Control software
Via AIR Control software, you can access an advanced
Bass Management mode. In this mode, all lters (Sat-
ellite, Sub 4 and Sub 2) can be controlled to suit de-
manding setups. See “Bass management page” on
page 74.