Specifications

AIR setups
Dynaudio Professional AIR reference manual – 2014-08-28 17
6.1 setup – analog
L
L
LR
R
R
6.1 setup – analog
Master
Left
Master
Left
surround
Master
Center
System Ctrl.
L R C
LFE
LS RS CS
Slave
Right
surround
Sub
Subwoofer
Slave
Right
Master
Center
surround
Fig. 8: This illustration shows how to connect an analog 6.1 setup.
Understanding and using this setup
►
The left monitor is set as the System Controller by
setting the TC Link button on the rear panel to the
“out” position.
►
The left monitor receives both the left and right
input signals.
►
The right monitor receives audio via the TC-LINK
RJ-45 connection from the left monitor.
►
The center monitor (C) receives both the center
and LFE channels.
►
The LFE monitor receives audio via the RJ-45
connection from the center monitor.
►
The left surround monitor (LS) receives both the
left and right surround channel signals.
►
The right surround monitor receives audio via the
TC-LINK RJ-45 connection from the left surround
monitor.
►
The center surround monitor receives only the
center surround signal.
►
Center Chain: Starting with AIR software version
1.10, it is possible to connect one or more Center
Chain monitors.
►
With no bass management, only the LFE signal is
fed to the subwoofer.
►
With bass management activated, low-frequency
information from the ve main channels is extract-
ed below the set crossover frequency and sent to
the subwoofer, where it is summed with the LFE
channel.
►
The AIR Remote or a computer running the AIR
Control software can be connected to any available
TC LINK Out connection.
►
Channels must be connected as follows:
►
Left channel to the left input on the left monitor.
►
Right channel to the right input on the left mon-
itor.