Specifications

AIR setups
Dynaudio Professional AIR reference manual – 2014-08-28 15
5.3 setup – digital
5.3 setup – digital
Master
Left
Slave
Left
surround
Master
Center
System Ctrl.
Slave
Right
surround
Sub
Left
subwoofer
Sub
Center
subwoofer
Sub
Right
subwoofer
Slave
Right
C + LFEL + LS R + RS
Fig. 6: This illustration shows how to connect a digital 5.3 setup.
Understanding and using this setup
►
The center monitor (C) is set as the System
Controller by setting the TC Link button on the rear
panel to the “out” position.
►
The left monitor receives both the left and left sur-
round input signals.
►
The right monitor receives both the right and right
surround input signals.
►
The left surround monitor is fed via the TC LINK
RJ-45 connection from the left monitor.
►
The right surround monitor is fed via the TC LINK
RJ-45 connection from the right monitor.
►
The center monitor (C) receives both center and
LFE channels.
►
The LFE monitor receives audio via the RJ-45
connection from the center monitor.
►
With bass management off, the left and right sub-
woofers will receive no signal.
►
With bass management on, …
►
low-frequency information is extracted from the
left and left surround signals and fed to the left
subwoofer.
►
low-frequency information is extracted from the
right and right surround signals and fed to the
right subwoofer.
►
low-frequency information is extracted from the
center signal, summed with the LFE channel
and fed to the center subwoofer.
►
The AIR Remote or a computer running the AIR
Control software can be connected to any available
TC LINK Out connection.