Specifications

AIR setups
Dynaudio Professional AIR reference manual – 2014-08-28 12
Stereo setup with two subwoofers – digital or analog
Stereo setup with 2 subs – digital or analog
Master
Left
System Ctrl.
L + R AES or analog signal
Slave
Right
Sub
Right
subwoofer
Sub
Left
subwoofer
Fig. 3: This illustration shows how to connect a stereo setup with two subwoofers.
Understanding and using this setup
►
The left monitor is set as the System Controller by
setting the TC Link button on the rear panel to the
“out” position.
►
The left monitor receives both the left and right
input signals.
►
The right monitor and the subwoofers receive
audio via the TC-LINK RJ-45 connection from the
left monitor.
►
With no bass management, no signal is sent to the
subwoofers.
►
With bass management activated, low-frequency
information is extracted from the left and right
channels below the set crossover frequency.
Low-frequency information from the left channel
is sent to the left subwoofer, and low-frequency
information from the right channel is sent to the
right subwoofer.
►
The AIR Remote or a computer running the AIR
Control software can be connected to any available
TC LINK Out connection.