Product specifications

Page 42 of 146 198-1600-00 Rev F
the selected digit. After the desired code is entered press the voltage encoder to accept
the new access code.
4) If the access code is changed an informational warning message is displayed to
indicate that the code has been changed. This screen displays “CHng” on the top
display and “COdE” on the bottom display. This screen is displayed for a short period of
time and can be skipped by pressing the voltage encoder switch.
5) After the warning message is displayed a confirmation screen is displayed. The top
display shows “CHng COdE” and the bottom display shows the confirmation selection.
Rotate the current encoder to change the confirmation selection. Select “yES” to accept
the access code change or “no” to cancel the change. Press the voltage encoder
switch to accept the selection and exit the “Unit Configuration Access Code System
Menu” and return to the “System Configuration Menu”.
6) From the “System Configuration Menu” rotate the current encoder until the display
shows “SyS” “End”. Then press the voltage encoder switch to exit the “System
Configuration Menu” and return to the “Unit Configuration Menu”.
7) If any settings were changed in the “System Configuration Menu” you will be prompted
to store the changes. Select “yES” to accept the changes or “no” to cancel the
changes. You must select “yES” to accept the changes to the access code.
6.3.10. Setting Unit Defaults
Most settings in the “Unit Configuration Menu” and the “Unit Setup Menu” can be reset to default
values from the “Set Defaults System Menu”.
The following settings are not affected by setting unit defaults.
 Calibration values
 Unit configuration password (access code)
 Hardware configuration options
Use the following procedure to reset settings to default values. The “System Configuration Menu”
is located within the “Unit Configuration Menu (see 6.3: Unit Configuration). See A.7.4: System
Configuration Menu and A.7.4.6: Set Defaults System Menu for more information regarding menu
navigation.
1) From the “Unit Configuration Menu” rotate the current encoder until the display shows
“CFg” “SyS”, and then press the voltage encoder switch to enter the “System
Configuration Menu”.
2) From the “System Configuration Menu” rotate the current encoder until the display
shows “SyS” “dFLt”, and then press the voltage encoder switch to enter the “Set
Defaults System Menu”.
3) The first screen in the “Set Defaults System Menu” shows “Set Unit dFLt” on the top
display and shows “yES” or “no” on the bottom display. Rotate the current encoder to
make a selection. Select “yES” to reset all settings to default values, or select “no” to
leave the settings unchanged. Press the voltage encoder switch to accept the
selection.