Product specifications

Diamond 36kW Manual Dynatronix, Inc.
198-1600-00 Rev F Page 21 of 146
Units using only Current Control and Read back should be wired as shown below. The voltage
level is set to maximum using a resistor.
Typical Analog Control Wiring (Current Control Only)
Connector Signals
1 shield gnd
2 no connection
3 dc common
4 +12 (50ma)
5 -volt cntl in
6 +volt cntl in
7 -curr cntl in
8 +curr cntl in
9 +volt rb out
10 -volt rb out
11 + curr rb out
12 - curr rb out
1
12
6
Analog Control Connector
IN
OUT
Controller (Current)
4-20ma, 0-5V or 0-10V
+
-
+
-
Earth
Gnd
Shields
Shields
Approximately
560 Ohm
Resistor, ½ Watt
Jumper