Owner`s manual

LAYER

Layer

The layer mode of the piano allows you to select and play two different voices

simultaneously in a layer. This makes it easy to create exceptionally rich and thick tonal

textures. The volume balance can be set for the two voices.

PLAYING WITH THE LAYER VOICE

① Select a main voice.

Select a voice in the normal way. (See the SELECTING VOICE section on page 13.)

② Call up the layer mode.

To call up the layer mode, press the LAYER button. Lamp lights and

the layer is set on.

③ Select the layered voice.

Select a voice in the normal way. (See the SELECTING VOICES section on page 13.)

ADJUSTING THE LAYER VOLUME

This determines the volume of the layered voice.

②

Adjust the layer volume by pressing secondary voice volume up(D#4) and down(C#4) keys.

☞ Refer to the FUNCTION KEY MAP on page 9.

☞ If you press both UP and DOWN keys at the same time, it automatically returns to the default secondary

voice volume (11). The range of volume is 0 ~ 16.

☞ Hold the key for continuous decrementing or incrementing.

☞ Both split and layer volumes can be adjusted by using secondary volume keys.

① Press and hold the SETUP button.

☞ The lamp is on.

☞ If you select a layer voice, layer function automatically can be on without pressing

the LAYER button.

SDP500 영영 영영영 Rev1_SDP500 영영영 (영영).qxd 2012-05-23 영영 4:57 Page 14