DYNAMITE SUZUKI INTRUDER 1400 1990-95 & 1996-00 MODELS DONA 3000 IGNITION INSTALLATION INSTRUCTIONS . REMOVE SEAT ~ The stock ignition location is under the main front seat. The rear seat back-rest can be pulled off, exposing the tool compartment cover. Remove the cover and the tool bag. Under the tool bag is a rubber bumper where the rear seat attached. Remove the rear seat, then remove the front seat, 2. REMOVE THE STOCK IGNITION BOX Tum Ignition Key OFF.
THE STATUS LED There is a red STATUS LED located next to the mode switches on the DONA 3000 module. This LED s useful for giving diagnostic information about the operation of your ignition. The Status LED has several functions. When you first apply power to the DONA 3000 module, the Status LED will blink once, indicating the module is on. This is a good verification that your ignition fuse, wiring and ignition switch is working.
DYNAMITE NOTE DASHED LINE INDICATES PART THROTTLE CURVE WHEN USING MAP SENSOR LIGHT LAUD WOT ADVANCE CURVES CURVES CURVE CURVE (RETARD) IGNITION ADVANCE (CRANKSHAFT DEGREES) RPM X 1000 DONA 3000 IGNITION SUZUKI INTRUDER 1400 ADVANCE CURVES
