Service manual

60 9650-0801-01 Rev. A
3 Disconnect multi-wire IBP cable with ferrite
in the area illustrated.
4 Cut the tie wrap to the IBP cable in the area
shown with the orange stick.
Note: During reassembly, secure a new tie
wrap to the IBP cable.
5 Disconnect the USB flex cable from ZIF
connector in the area illustrated.
6 Lay front end of separated unit down with
opened side facing up.
7 Disconnect the black EtCO
2
tube
connector from the air vent.
8 Remove four (4) screws in the areas
illustrated to release the silver EtCO
2
module.
Note: During reassembly, torque screws to
6 in-lbs.
multi-wire IBP cable