Service manual

Removing the Display Module
9650-0801-01 Rev. A ZOLL Propaq MD Service Manual 57
Removing the Display Module
Tools Required
• #1 Phillips screwdriver with torque capability
• 3M copper adhesive tape
• 6mm socket wrench
Setup
• This procedure should be conducted on a static mat.
• Wear a wrist strap to ground during the procedure.
• Complete these procedures in the following order before performing this procedure:
1. “Disassembling the Main Unit” on page 52
2. “Removing the Front Enclosure Module” on page 55
To reinstall the display module, reverse the steps.
Display Disassembly
1 Place the back of the unit down on the mat
so that the display screen is facing up.
2 Remove the six (6) screws from the front of
the casting in the areas illustrated.
Note: During reassembly, torque screws to
6 in-lbs.
3 Flip the unit over and remove the screw in
the area illustrated.
4 Remove the hex standoff located
underneath the screw you just removed.
Note: During reassembly, torque to
6 in-lbs.
hex standoff