Service manual

Removing the Front Enclosure Module
9650-0801-01 Rev. A ZOLL Propaq MD Service Manual 55
Removing the Front Enclosure Module
Tools Required
• #2 Phillips screwdriver with torque capability
• Orange (wooden) stick
Setup
• This procedure should be conducted on a static mat.
• Wear a wrist strap to ground during the procedure.
• Complete these procedures in the following order before performing this procedure:
1. “Removing the Handle” on page 49
2. “Disassembling the Main Unit” on page 52
To reinstall the front enclosure module, reverse the steps.
Front Enclosure Disassembly
1 Remove tape from the top of the unit.
2 Separate monitor front enclosure.
3 Pivot top up with cables still connected.
4 Remove grounding screw as shown in the
illustration.
Note: During reassembly, torque screw to 6
in-lbs.
5 Disconnect the front panel multi-wire cable
in the area illustrated.
grounding
screw
multi-wire
cable