Service manual

Service Manual Repair Procedures 53
single battery cover removal
2. Disconnect the battery pack cable from the battery pack.
3. Remove the battery pack from the monitor.
4. Store the battery in a safe place while disassembling the monitor.
Removing the Dual Battery in Expansion Module
The expansion module uses a dual battery pack. The following instructions describe how
to remove the dual battery.
1. Using a Phillips screwdriver, remove the four screws securing the expansion module
to the monitor (see figure below).
0696-13
Battery
Pack Cable
Battery
Pack
Battery
Cover
Note
Four screws secure the expansion module to the monitor. Four additional screws
secure the rear panel to the expansion module chassis; do not remove these
additional screws.