Service manual

Service Manual Overview 9
Self Test and Service Menus
The Encore monitor includes built-in self-tests that verify the integrity of its hardware and
software each time you turn it on. If the monitor turns on and displays the Main Menu, all
self-tests were passed. If a self-test results in a failure, a message and error code are
displayed indicating the failure mode. Refer to “Troubleshooting” on page 43 and contact
Welch Allyn Technical Support for help.
The Encore monitor contains software routines that make the Functional Verification and
Calibration procedures quicker and easier. You access these routines through the Service
Menus as indicated in each of the procedures.
The figure below shows the hierarchy of the Service Menus once you enter the top level
Service Menu.
The procedures in this manual indicate which buttons to push by separating each button
menu name with the (>) character. For example, to access the Service Menu, the
procedures would indicate for you to press SETUP > MORE > MORE > SERVICE > YES,
which means you press the SETUP button, then the MORE button, then the MORE
button, then the SERVICE button, and finally the YES button.
service menus
Note
The figure illustrates all Service Menu functions. Some of these functions are not
available if you do not have the appropriate option.
NIBP TEST IBP TEST SpO2 TST CO2 TEST MORE
PUMP TEST AUTO PMP NIBP CAL ZERO PREV MENU
MAIN CAL MAIN TEST SIDE CAL SIDE TEST
PREV MENU
TEMP TEST PIXL TEST NET TST MORE
CYCLE CHECKER 1 CHECKER 2 BORDER PREV MENU
LOOP TEST OUT TEST PREV MENU
SETTINGS KEY TEST SYSTEM
MORE
KEY 0 KEY 1 KEY 2 KEY 3
PREV MENU
NEXT CHANGE ALL ALARM
PREV MENU
(Software v. 2.5X only)