Operating instructions

Swim Spa Operator’s Guide
BASIC INFORMATION
Congratulations on the purchase of your new spa. Our goal is to provide you with a warm and
relaxing spa which incorporates a soothing water massage. In order to maximize the pleasure of
your spa, you will need to understand how it works.
The following operating and maintenance instructions are very important and must be followed
carefully. With proper care and maintenance your spa will provide you with years of satisfaction with
minimum effort.
CAUTION!
CAUTION: Cover must be kept on spa at all times when spa is drained or winterized.
Direct exposure to sunlight can damage plastic parts and interior surface, jets, or any
interior components. Damage caused by exposure to the sun will not be covered under
warranty.
Do not use soft water. It may harm your acrylic.
WARNING!
•
•
•
•
•
•
The pump and heater should be operated a minimum of two hours per day for cleaning and
heating.
The length of time required to heat your spa to the desired water temperature will vary,
depending on the air temperature, season, and wind velocity. We highly recommend using
a vinyl hard cover to minimize heat loss and to protect your spa when not in use. Covers are
available from your local Spa dealer.
The replaceable filter cartridge is trouble free and easy to clean. A routine cleaning is the best
practice. Make sure the pump is off, then remove the cartridge. Wash it off using a water hose
with a pressure nozzle and then reassemble. This should be done on a monthly basis.
Keep the spa water level 2” (5cm) above the skimmer. Never allow the water level to drop
below the bottom of the skimmer opening. If the water level is too low, the skimmer will allow
air into the water lines of the pump, causing it to lose its prime (water flow). Running the pump
without water flow will damage the pump seal assembly and could possibly result in further
equipment damage, which will not be covered under warranty.
If your spa has a natural wood skirt or if you purchased a gazebo, we recommend applying a
wood sealer of your choice (always follow application instructions) to protect the finish. Repeat
as directions suggest.
You should clean your spa at least every 3-4 months. Drain the spa water and use a gentle
liquid cleanser. DO NOT use hard brushes or abrasive cleaners. Fill with regular tap water and
chemically treat the water for a clean and healthy spa.
9