Installation Guide

Installation Instructions
Tools Needed:
1) Position the mounting bracket on the wall at the desired location for your new hardware. Using a
pencil mark the location of the holes for the mounting bracket on the wall. Try to mark exactly in
the middle of each hole in the bracket. When installing towel bars or toilet paper holders use a level
to insure the marks on the wall are at the same height so the hardware will be mounted level.
2A
)
Drill two holes using a 1/4" diameter drill bit at the two pencil marks on the wall.
3)
Insert the two plastic anchors into the holes.
4)
Hold the mounting bracket over the anchors and line up the holes in the bracket with the holes in the
anchors. Insert the screw and tighten with a hand held screw driver.
5)
Loosen the set screw using the enclosed allen wrench. Slide the new hardware over the mounting
bracket. Carefully tighten the grub screw.
Use a stud finder to determine if you are mounting directly over a stud. If mounting directly over
a stud in the wall drill small pilot holes and attach the mounting bracket using just screws. After
Attaching bracket skip to step 5. **If you are installing into a hollow wall move on to step 2B.
2B)
Parts Included:
Plastic Anchors
Mounting Screws
Mounting Brackets
Allen Wrench
Pencil
Stud Finder
Level
Electric or Cordless Drill
1/4" Drill Bit
Screw Driver
** When installing towel bars or toilet paper holders place the hardware on a flat surface as if it were mounted on the wall
measure the exact distance between the center of one set screw to the center of the other set screw. The distance bteween
the set screws is the distance you should use to install the mounting brackets on the wall. This dimension will be from the
center of one bracket to the center of the other bracket.
-----------------------------------------------------------------------------------------------------------------------------------------------