User Manual

Preliminary document not for redistribution. Company confidential. Product features and specifications may vary.

Device Pairing

Each sports device (footpod, heart rate monitor) has a unique digital ID that must be stored in the wristwatch to

enable the watch to connect to the appropriate device during activity. Each device must be ‘paired’ with the watch.

• Prior to pairing, the footpod and heart rate monitor must first be turned on, see page 5, Quick Start Steps.

• To place the wristwatch into the pairing mode, enter the SPORT mode Adjust menu and execute “PUSH PAIR”,

as detailed on page 13, SPORT Mode Adjustment Settings.

• Pairing will complete within 15 seconds. A message “Paired Pod” or “Paired Heart” indicates success.

• *** Ensure that only the device to be paired is within 10 meters of the watch. This will prevent unintentional

pairing with wrong devices.

• *** Only one device ID per device type (footpod, heart rate monitor) can be stored in the watch at a time. If a

device is found during a pair procedure, the previously stored device is overwritten. If no device of a particular

type is found during a pair procedure, then the stored ID remains intact.

INITIAL SYSTEM SETUP

• If your sports system was shipped as a complete set (wristwatch, footpod, and heart rate monitor) then pairing

before use is not necessary; pairing is done at the factory. Devices will therefore be found automatically

within 10 seconds when they are turned on and the watch is placed into SPORT mode.

BATTERY REPLACEMENT

• The pair operation must be repeated following heart rate monitor battery replacement, since the heart rate

monitor regenerates its unique ID upon battery replacement.

• The pair operation does NOT need to be repeated following wristwatch or footpod battery replacement.

NEW DEVICES

• To pair a newly purchased footpod or heart rate monitor into an existing watch system, perform a pairing

operation in isolation with the new device. The previously paired device will be overwritten.