User's Manual
You can attach the speed sensor to either sneaker. It is important to be
consistent in how you attach it. Make sure it is attached it to the laces
securely enough that there is no “wobble” when you are running. Finally,
it should be aligned with the foot and secured well enough that the
alignment does not change during a run.
1. Lace the speed sensor clip into your
sneakers before you attach the speed
sensor itself.
2. Then attach the speed sensor to the clip as
shown.
DIRECTIONS FOR NORMAL USE
Follow these instructions for normal use of the
speed sensor.
The speed sensor is equipped with a power
button. When not in use, store the speed sensor
with the power off to conserve battery life.
TURN POWER ON
Press the power button. A light will indicate
that the speed sensor is activated. The watch
will begin linking when it receives a signal
from the speed sensor. When running or
walking, your speed and distance information
is automatically transmitted to your watch.
TURN POWER OFF
Press and hold the power button. The light will
turn off, indicating that the power is off.
7
ATTACHING THE SPEED SENSOR TO YOUR SNEAKER
Attach sensor to clip as shown.
6
The core of the SDM Triax 100 watch technology is housed in a speed
sensor, which you attach to one sneaker. A patented technology calculates
your speed and distance and transmits that information to your watch. Of
course, you can always use your watch without the speed sensor as a
multi-function sport timepiece. When running or walking, your speed and
distance information is automatically transmitted to your watch.
FIRST USE SETUP
IMPORTANT
The first time you use the speed
sensor, when you change the watch
battery, or when you reset the watch
by pressing all buttons, you will have
to "train" the watch to recognize the
speed sensor. (Reset the watch when
you replace the speed sensor with a
new one or borrow a friend's speed
sensor.)
FIRST TIME USE: “Training” the
speed sensor to recognize the
watch
1. Proceed to RUN mode by
pressing MODE on the
watch until RUN appears.
* The watch will prompt you
to press and hold the
button on the speed sensor
when it recognizes that
there is a new speed sensor
present. “HOLD speed sensor
button” will be displayed on the watch.
2. When the speed sensor is off, press and hold the button until the
watch stops scrolling the message. The “training” takes just a few
seconds, after which, your Triax SDM is ready to use.
THE SPEED SENSOR
Lace the speed sensor clip
into your sneakers before you
attach the sensor itself
LED
ON/OFF BUTTON
SPEED SENSOR
CHANGING THE CHANNEL
In the event that you receive “crosstalk” from another Triax SDM, you can
select a different channel.
With the power on, briefly press the button on the speed sensor. The
watch and speed sensor will begin linking on a new channel.
9328.2- SDM-ENG 6/13/00 5:51 PM Page 6