User's Manual

Preliminary
Dynastream Innovations Inc.
Company Confidential
TITLE: FIT1/e USER MANUAL Rev 0.A
DOCUMENT NO: D00001279 SHEET: 9 of 9
To comply with FCC regulations, it is required that fitness equipment containing the FIT1/e display a label
referring to the enclosed module. This exterior label must use wording similar to the following:
“Contains FCC ID: O6RFIT1” (note: First Character is the letter O, not the # 0)
This equipment generates, uses and can radiate radio frequency energy and may cause harmful interference to
radio communications if not installed and used in accordance with the instructions. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet that is on a different circuit from the receiver.
• Consult the dealer or an experienced radio/TV technician for help.
This product does not contain any user-serviceable parts. Unauthorized repairs or modifications could result in
permanent damage to the equipment, and void your warranty and your authority to operate this device under
Part 15 regulations.
5.2 Industry Canada Compliance
Category I radio communication devices comply with Industry Canada Standard RSS-210.
To comply with Industry Canada regulations, it is required that fitness equipment containing the FIT1/e display
a label referring to the enclosed module. This exterior label must use wording similar to the following:
“Contains IC ID: 3797A-FIT1”
5.3 CE Declaration of Conformity
This device is declared to be in conformance with the essential requirements and other relevant provisions of
Directive 1999/5/EC, as a low-powered unlicensed transmitter:
• EN 60950-1:2001 Safety of Information Technology Equipment
• EN 300 440-2 v 1.1.2 Electromagnetic compatibility and Radio Spectrum Matters (ERM): Short range
devices.
• EN 301 489-3 v 1.4.1 Electromagnetic compatibility and Radio Spectrum Matters (ERM): Short range
devices.
• EN 61000-6-1 Generic Immunity Standard
5.4 Japan
This device complies with ARIB STD-T66
5.5 Australia & New Zealand
This device complies with AS/NZS 4268:2003 Radio equipment and systems – Short range devices.