User's Manual

Page 15 of 20 D52Q ANT Module Datasheet, Rev 0.4
dynastream.com thisisant.com
The D52Q ANT SoC module series, when loaded with ANT and/or BLUETOOTH low energy stack, has
received regulatory approvals in the United States (FCC) and Canada (IC), and has been verified to
conform to the appropriate regulations in Europe, Australia and New Zealand, and Japan; other regions
TBD. The module series has been qualified by BLUETOOTH SIG. Such approvals and qualification allow
the user to place the module inside a finished product and, in most cases, not require regulatory testing
for an intentional radiator, provided no changes or modifications are made to the module circuitry. This
does not preclude the possibility that some other form of authorization or testing may be required for
the finished product. Changes or modifications could void the user’s authority to operate the
equipment. The end user must comply with all of the instructions provided by the Grantee, which
indicate installation and/or operating conditions necessary for compliance.
8.1 United States
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
A host product manufacturer is responsible for ensuring compliance with the module(s) installed and fully operational. For
example, if a host product was previously authorized as an unintentional radiator under the Declaration of Conformity
procedure without containing a certified transmitter module, then a module is added, the host manufacturer is responsible
for ensuring that the host continues to be compliant with the Part 15 subpart B unintentional radiator requirements after the
module is installed and operational. Because this may depend on the details of how the module is integrated within the
host, the module grantee (the party responsible for the module grant) shall provide guidance to the host manufacturer for
ensuring compliance with the Part 15 Subpart B requirements.
This module is limited to OEM installation ONLY. The OEM Integrator is responsible for ensuring that the end-user has no
manual instructions to remove or install the module. Changes or modifications not expressly approved by Dynastream could
void the user's authority to operate the equipment.
If (1) the module’s FCC ID is not visible when installed in the host, or (2) if the host is marketed so that end users do not
have straightforward commonly used methods for access to remove the module so that the FCC ID of the module is visible;
then an additional permanent label referring to the enclosed module: “Contains Transmitter Module FCC ID: O6R3067” or
“Contains FCC ID: O6R3067” must be used. The host OEM user manual must also contain clear instructions on how end
users can find and/or access the module and the FCC ID.
8.2 Canada
This device complies with Industry Canada’s license-exempt RSSs. Operation is subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.