User's Manual

ANT C7 RF Transceiver Module Page 13 of 20
thisisant.com
3. Electrical Specifications
3.1 Absolute Maximum Ratings
(1)
PARAMETER TEST CONDITIONS Min Max Unit
Supply voltage
All supply pins must have the same voltage -0.3 3.9 V
Voltage on any digital pin
-0.3 VDD+0.3, ≤ 3.9 V
Input RF level
10 dBm
Storage temperature
range
-40 85 °C
ESD
All pads, according to human-body model,
JEDEC STD 22, method A114
2 kV
According to charged-device model, JEDEC
STD 22, method C101
500 V
(1) Stresses beyond those listed under Absolute Maximum Ratings may cause permanent damage to the device.
These are stress ratings only and functional operation of the device at these or any other conditions beyond those
indicated under Recommended Operating Conditions is not implied. Exposure to absolute-maximum-rated
conditions for extended periods may affect device reliability.
3.2 Recommended Operating Conditions
Over operating free-air temperature range (unless otherwise noted)
PARAMETER Min Max Unit
Operating ambient temperature range, T
A
-40 +85 °C
Operating supply voltage 2.0 3.6 V
3.3 ELECTRICAL CHARACTERISTICS
Measured with T
A
= 25°C and V
CC
= 3 V
PARAMETER TEST CONDITIONS Min Typ Max Unit
I – Current consumption
Peak RX current consumption 23.7 mA
Peak TX current consumption, -6 dBm output power 25.9 mA
Peak TX current consumption, 0 dBm output power 28.8 mA
Peak TX current consumption, +4 dBm output power 34.3 mA
Power-down current, 32 kHz oscillator active 1.0 µA
Power-down current, 32 kHz oscillator disabled 0.5 µA
3.4 RF Characteristics
Measured with T
A
= 25°C and V
CC
= 3 V
PARAMETER TEST CONDITIONS Min Typ Max Unit
RF frequency range Programmable in 1 MHz steps 2400 2495 MHz
Data rate and modulation format 1 Mbps, GFSK, 160 kHz deviation