Owner's manual

ENet
Site Name0.00 GPM
1/16/2013
2:18 PM
SystemSite I/O CalAdv
Display
Meter Log
ENet
Comm
Update
PC
Storage
Disk
Power TimeMisc
Edit
Edit
Enable ModbusTCP Server
Server Active Activity Error
Network Connected
Modbus TCP Status and Control
Network Interface Status and Settings
IP Address
Subnet Mask 255.255.255.0
192.168.0.100
Figure 106: System Ethernet (ENet)
Time
The System>Time page provides date and time setting controls. The current date is conveniently shown on a calendar page
with the currently programed date highlighted in blue.
Site Name0.00 GPM
1/16/2013
2:18 PM
SystemSite I/O CalAdv
Display
Meter Log
Time
Comm
Update
PC
Storage
Disk
Power ENetMisc
2013Year
1Month
16Day
14Hour
18Minute
24Second
January, 2013
Sun Mon Tue Wed Thu Fri Sat
1 2 3 4 5
6 7 8 9 10 11 12
13 14 15 16 17 18 19
20 21 22 23 24 25 26
27 28 29 30 31 1 2
3 4
30 31
5 6 7 8 9
Today: 1/16/2013
Click to Edit
Time
Wednsday, January 16, 2013 2:18:24 PM
Figure 107: System Time
To access the date/time controls click the button that says Click to Edit Time. When this button is pressed, all the date/time
controls on the right side of the screen will become active and the button will now say "Click to Set Time".
Next using the Increment and Decrement buttons set the correct date and time. When the date and time parameters have
been set up, press the Click to Set Time button to load the settings into the DXN’s memory.
Update
The System>Update page is used in conjunction with software updates supplied by Dynasonics to install new software
revisions into the DXN. For complete updating instructions, see Upgrading Software in the Appendix.
Installation & Operation Manual
Page 79 February 2013