Owner's manual

Left and Right Axis Data
The Left and Right Axis Data controls the choice of parameters to be shown on the respective axis. The choices are listed in
Table 6. When the control is pressed a drop-down menu appears. Choose the desired parameter by highlighting it with the
blue box and then press the Set button to load the parameter. Press the X button exit the drop-down menu.
Flow Energy POS TT Delta T RTD2 Temperature
Totalizer NET Energy DOP TT Delta T Raw RTD Delta Temp
Totalizer POS TT Flow TT TOF Bias Raw IO Voltage In
Totalizer DOP TT Gain TT TOF Fluid IO Digital In
Flow Velocity TT Quality TT Fluid SOS IO Voltage Out
Hybrid Mode DOP Flow DOP Flow Velocity IO Current Out
Reynolds Number DOP Gain DOP Frequency IO Digital Out
Power DOP Quality TT Aperture Start
Energy NET TT Flow Velocity RTD1 Temperature
TT = Transit Time DOP = Doppler
Table 6: Y Lt and Y Rt Axis Parameter Choices
Time Range
The Time Range control allows the choice of time period to be shown on the X axis. The choices are listed in Table 7. When the
control is pressed a drop-down menu appears. Choose the desired parameter by highlighting it with the blue box and then
press the Set button to load the parameter. Press the X exit the drop-down.
10 Seconds 30 Minutes 1 Day 14 Days
30 Seconds 1 Hour 5 Days 1 Month
1 Minute 5 Hours 7 Days 6 Months
10 Minutes 10 Hours 10 Days 1 Year
Table 7: Time Axis Choices
Clear Graph Data
To clear any current graphing data and return the graph scaling to factory defaults, first press the Unlock Graph Data Clear
button. A green check mark appears and the Delete Graph Data button turns red.
Site Name0.00 GPM
3/28/2012
13:24
Display
Meter Adv Cal System
Site
Log I/O
Alerts
GraphMeters
Table
Graph Setup
Right Axis Data
Left Axis Data
Flow
Totalizer Net
Time Range
10 Seconds
Delete Graph Data
Unlock Graph Data Clear
Delete Graph Data
Figure 48: Delete Graph Data
Press the red Delete Graph Data button. The graph resets to factory defaults and the Delete Graph Data button turns gray.
Installation & Operation Manual
Page 37 February 2013