R-58 - User Manual

Channel name edit
1. press the MENU and ENT button;
2. turn the Encoder knob until ‘NAME?’(menu 15) is displayed
1. push ENTER;
2. turn the Encoder knob to select ON/OFF;
3. press ENTER
4. press the VFO/MR to exit
Repeater shift adjustment (for communications through repeaters)
1. Press the MENU and ENT button;
2. rotate the Encoder knob until ‘OFFSET’(menu 16) is displayed
3. push ENTER;
4. turn the Encoder knob and select the repeater shift. (VHF range 0-42Mhz,
UHF range 0-80Mhz)
5. press ENTER ;
6. press the VFO/MR to exit
Repeater shift (for communications through repeaters)
To activate this function, follow these steps:
1. Press the MENU and ENT button;
2. rotate the Encoder knob until ‘S-D?’(menu 17) is displayed
3. push ENTER;
4. Turn the Encoder knob and select the repeater shift. You can choose amongst
the following options +, - and 0;
5. press ENTER again;
6. press the VFO/MR to exit
Wide and Narrow band selection
1. press the MENU and ENT button;
2. turn the Encoder knob until ‘N/W?’(menu 18) is displayed
3. push ENTER;
4. turn the Encoder knob to select from NARROW or WIDE.
5. press ENTER
6. press the VFO/MR knob to exit
Automatic Numbering Identification (ANI) setting
You can set an automatic number identifier visible from the radio’s display of
your partner each time you send a call signal.:
To activate it or select different mode:
1. press the MENU and ENT button;
2. turn the Encoder knob until ‘ANI’(menu 19) is displayed
3. push ENTER;
4. turn the Encoder knob to select ON/OFF