Product Manual
Oximeter SerieSOximeter SerieS
PULSE OXIMETER INSTRUCTION MANUAL
9
EMC requirements. Mobile phones, X-ray equipment or
MRI devices are a possible source of interference as they
may emit higher levels of electromagnetic radiation.
• Unplug the sensor from the Oximeter before cleaning or
disinfecting it. If liquid is accidentally spilled on the unit,
clean and dry thoroughly before reuse.
• Do not try to use the SpO
2 and NIBP measurement on
the same arm at the same time. This could potentially
aect measurement accuracy.
• At the end of its service life, the equipment must
be disposed of in compliance with the guidelines
regulating the disposal of such products. If you have any
questions concerning disposal of the equipment, please
contact your distributor.
• Always install or carry the equipment properly to avoid
damage caused by drop, impact, strong vibration or
other mechanical force.
NOTES
• Put the equipment in a location where you can easily see
the screen and access the operating controls.
• Keep this manual in the vicinity of the equipment so that
it can be obtained conveniently when needed.
• The software was developed in compliance with
IEC60601-1-4. The possibility of hazards arising from
software errors is minimized.
• SpO
2 measurements may be inuenced by high ambient
light, especially sunlight. Shield the sensor area if necessary.