Product Manual
5
Important: Prior to initial operation, the nebulizer should be
thoroughly cleaned by referring to the “Cleaning Procedures”
in the manual.
3. Gently twist the top part of the nebulizer counter-
clockwise to disassemble the nebulizer.
4. Fill the bottom section of the
nebulizer with the medication
prescribed by your physician.
Be sure that the cone is put
inside the bottom section.
5. Gently twist the top part clockwise to reassemble the
nebulizer.Besurethetwosectionstwell.
6. Attach one end of air tube to the base of the nebulizer.
7. Attach the other end of air tube to the air tube connector
located on the front of the compressor.
8. Attach mouth piece or mask per your choice to the top
section of nebulizer.
9. Plug the power cord into an appropriate electrical outlet.
Make sure at this stage, the power switch is at “O”
status.
10. Press power switch to begin your prescribed treatment.
Important:
The compressor motor has a thermal protector which will
shut off the unit before the unit is overheated. When the
thermal protector shuts the unit off, please:
a. Switch off the unit.
b. Unplug the unit from the electrical outlet.
c. Wait 30 minutes for the motor to cool down before
another treatment. Make sure the air openings are not
obstructed.
11. Whentreatmentisnished,shutofftheunitandunplug
it from the electrical outlet.
Place cone inside
and ll medication