User's Manual

User Manual:
1. Plug the USB receiver into the PC USB port. The green LED will shine 3
times showing that the connection between the receiver and PC is OK.
2. Put the batteries in the mouse then switch on. The LED will shine.
3. Press the mouse ID setting button once, its optical LED will turn dark.
4. Press the receiver ID setting button once, its LED will shine green slowly.
5. After ID setting of mouse and receiver, the green light of receiver will stop
shinning and the mouse LED will shine again, which shows the connection
is OK.
6. The green LED of receiver will shine while users slide it; and if not being
slided, it will not shine.
7. When the batteries are under low power , its low power indicator will shine
blue and the receiver will shine red to remind users to change batteries.
8. There are 3 processes before the mouse turns into sleep (power saving)
mode. 1st process: After 8 sec of stop using the mouse, its optical LED
will shine quickly, lasting 7 min (consumption current 1.2mA); 2nd process:
After 7 min, the LED will shine slowly, lasting 1 min (consumption current
1.2mA); 3rd process: after 8 min, the mouse optical LED will be darkened
(power saving sleep mode)
9. When the mouse is in sleep mode, users have to click its button to wake it
up.
NOTE:THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR
TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO
THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER
AUTHORITY TO OPERATE THE EQUIPMENT.