User Manual

Figure 9 - New Spot
10
First, choose the DynaLogger
model to be registered (TcA, AS or HF) and
then add the identification of the
monitoring point.
To associate the DynaLogger with
the spot in question, touch the icon ( ) in
the “DynaLogger” section.
A screen will appear showing
DynaLoggers within the Bluetooth range
of the device.
Once the desired DynaLogger has
been selected, the following parameters
must be set in order to complete the spot
settings.
• Sample interval: the value that
defines the frequency of data collection,
that is, time delay between
measurements.
• Sensors for monitoring: defines
which parameters will be collected by the
associated DynaLogger.
• Default Spectrum: defines the
duration and maximum frequency
characteristics of the standard spectrum.
This information is important for spots
that will be collected by the Dynamox
Gateway (automatic collection).
3.4.1 New Spot
By pressing the icon ( ), the registration form for a new spot is dis-
played. On this screen it is possible to associate and configure all of the moni-
toring parameters of the DynaLogger.
DynaPredict Application Descriptive Manual - Version 3.0 (16/04/2021)
RMP - Publication controlled by SGI