User manual
Dynamix UM-SB Series User Manual V0.06
39
The parameters in WAN Number 1 has been setup in Basic Setup.
If you want to setup another PVC, you can configure in WAN 2 to WAN 8.
Enter the parameters:
Protocol: If WAN Protocol is PPPoA or PPPoE with dynamic IP, leave the default WAN IP Address
and Subnet Mask as default setting. The system will ingore the IP Address and Subnet Mask
information, but erasion or blank in default setting will cause system error.
If the WAN Protocol is IPoA or EoA, leave the ISP parameters as default setting. The system will
ingore the information, but erasion or blank in default setting will cause system error.
VC-mux (VC-based Multiplexing): Each protocol is assigned to a specific virtual circuit. VC-based
multiplexing may be dominant in environments where dynamic creation of large numbers of ATM
VCs is fast and economical.
LLC (LLC-based Multiplexing): One VC carries multiptle protocols with protocol identifying
information being contained in each packet header. Deapite the extra bandwidth and processing
overhead, this method may be advantagrous if it is not practical to have a sepatate VC for each
carried protocol.
VPI (Virtual Path Identifier) is for set up ATM Permanent Virtual Channels(PVC).The valid range for