User manual

Dynamix UM-SB Series User Manual V0.06
128
Active interface number <1~8>: 1
----------------------------------------------------------------------
The screen will prompt as follow:
>>
attrib
Operation, authentication and Poison reverse mode
version
RIP protocol version
authe
Authentication code
Attrib command can configure RIP mode, authentication type and Poison reverse mode.
Version command can configure RIP protocol version.
Authe command can configure authentication code.
Interface RIP Parameter:
Interface
(LAN, WAN1~8)
RIP Mode
□Disable □Enable □Silent
Authentication type
□None □Password □MD5
Poison reverse mode
□Disable □Enable
RIP protocol version
□Ver.1 □Ver.2
Authentication code
You can review the list of RIP parameters via list command.
5
5
.
.
1
1
2
2
.
.
8
8
L
L
A
A
N
N
LAN interface parameters can be configured LAN IP address, subnet mask and NAT network type.
-------------------------------------------------------------------------------
Command: setup lan <1~1> <more...>
Message: Please input the following information.
Interface number <1~1>:1
-----------------------------------------------------------------------------
There are only one LAN port, so type 1 and press ENTER.
-----------------------------------------------------------------------------
>>
ip_type
IP type
address
LAN IP address and subnet mask
attrib
NAT network type
Ethernet
Media type
----------------------------------------------------------------------------
Ip_type can set up this IP is Fixed or Dynamic.
Address can set up IP address and subnet mask.
Attrib can set up NAT network type: Global or Virtual.
Ethernet item can set up the PHY parameters on this LAN port: Auto, 100M-Full, 100M-Half,
10M-Full and 10M-Half.
LAN Port parameter: