User manual

Dynamix UM-SB Series User Manual V0.06
127
20
You can delete the static route information via delete command.
You can review the static route entry by using list command.
5
5
.
.
1
1
2
2
.
.
7
7
.
.
2
2
R
R
i
i
p
p
To configure Routing Information Protocol (RIP), you can use rip command to setup the
parameters. Move the cursor “>>” to rip and press enter.
>>
generic
Configure operation and auto summery mode
lan
Configure LAN interface RIP parameters
wan
Configure WAN interface RIP parameters
list
Show RIP configuration
Generic command can setup RIP mode and auto summery mode.
Generic RIP Parameters
Generic RIP Parameter:
Rip Mode
□Disable □Enable
Auto Summary
□Disable □Enable
Interface RIP Parameters
[ LAN ]
If there are any routers in your LAN, you can configure LAN interface RIP parameters via lan
command.
-----------------------------------------------------------------------------
Command: setup route rip lan <1~1> <more...>
Message: Please input the following information.
Active interface number <1~1>:
-----------------------------------------------------------------------------
The screen will prompt as follow:
-----------------------------------------------------------------------------
>>
attrib
Operation, authentication and Poison reverse mode
version
RIP protocol version
authe
Authentication code
-----------------------------------------------------------------------------
[ WAN1 ~ WAN8 ]
The product supports 8 PVCs and you can configure the RIP parameters of each WAN via wan
command. Move the cursor “>>” to wan and press enter.
----------------------------------------------------------------------
Command: setup route rip wan <1~8> <more...>
Message: Please input the following information.