User manual

Dynamix UM-SB Series User Manual V0.06
126
you do not want to setup the route parameters. Move the cursor “ >> “ to route and press enter.
>>
static
Configure static routing table
rip
Configure RIP protocol
5
5
.
.
1
1
2
2
.
.
7
7
.
.
1
1
S
S
t
t
a
a
t
t
i
i
c
c
If the Router is connected to more than one network, it may be necessary to set up a static route
between them. A static route is a pre-determined pathway that network information must travel to
reach a specific host or network.
With Dynamic Routing, you can enable the Router to automatically adjust to physical changes in
the network’s layout. The Router, using the RIP protocol, determines the network packets’ route
based on the fewest number of hops between the source and the destination. The RIP protocol
regularly broadcasts routing information to other routers on the network.
You can setup 20 sets of static route in static command. After entering static menu, the screen will
show as follow:
>>
add
Add static route entry
delete
Delete static route entry
List
Show static routing table
You can add 20 sets of static route entry by using add command. Type the IP information of the
static route including IP address, subnet mask and gateway.
Static Route Table:
IP Address
Subnet Mask
Gateway
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19