User manual

Dynamix UM-SB Series User Manual V0.06
125
5
5
.
.
1
1
2
2
.
.
5
5
.
.
2
2
P
P
o
o
r
r
t
t
B
B
a
a
s
s
e
e
d
d
V
V
L
L
A
A
N
N
With port-based VLAN, the port is assigned to a specific VLAN independent of the user or system
attached to the port. This means all users attached to the port should be members in the same
VLAN. The port based setting performs the VLAN assignment. The port configuration is static and
cannot be automatically changed to another VLAN without manual reconfiguration.
For Port Based VLAN, user must set up the table using 802.11Q methods. But don’t care the value
of VID , PVID or link type.
Port Based VLAN:
No.
LAN1
WAN1
WAN2
WAN3
WAN4
WAN5
WAN6
WAN7
WAN8
1
2
3
4
5
6
7
8
To view the VLAN table, move the cursor to list and press enter.
5
5
.
.
1
1
2
2
.
.
6
6
S
S
T
T
P
P
Spanning-Tree Protocol (STP) is a link management protocol that provides path redundancy while
preventing undesirable loops in the network. For an Ethernet network to function properly, only one
active path can exist between two stations
The default is disable.
>>
active
Trigger Bridge STP function
STP:
STP Function
□Disable □Enable
Once you enable the STP feature, you can see the STP status will follow IEEE 802.1d standard to
work. The working steps are Blocking, Listening, Learning and forwarding.
5
5
.
.
1
1
2
2
.
.
7
7
R
R
o
o
u
u
t
t
e
e
You can setup the routing parameters in route command. If the product is configured as a bridge,