User manual
Dynamix UM-SB Series User Manual V0.06
121
voice over IP and video comferencing, that require tightly constrained delays and delay variation.
VBR-rt is characterized by a peak cell rate (PCR), substained cell rate (SCR), and maximun burst
rate (MBR).
VBR-nrt (Varible Bit Rate non-real-time) is intended for non-real-time applications, such as FTP,
e-mail and browsing.
PCR (Peak Cell Rate) in kbps: The maximum rate at which you expect to transmit data, voice and
video. Consider PCR and MBS as a menas of reducing lantency, not increasing bandwidth. The
range of PCR is 384kbps to 11392kbps
SCR (Substained Cell Rate): The sustained rate at which you expect to transmit data, voice and
video. Consider SCR to be the true bandwidth of a VC and not the lone-term average traffic rate.
The range of SCR is 384kbps to 11392kbps.
MBS (Maximum Burst Size): The amount of time or the duration at which the router sends at PCR.
The range of MBS is 1 cell to 255 cells.
5
5
.
.
1
1
2
2
.
.
3
3
.
.
6
6
I
I
S
S
P
P
ISP command can configure account name, password and idle time. Idle time is from 0 minute to
300 minutes.
5
5
.
.
1
1
2
2
.
.
3
3
.
.
7
7
I
I
P
P
T
T
y
y
p
p
e
e
Most of the ISP use dynamic IP for PPP connection but some of the ISP use static IP. You can
configure the IP type: Dynamic, Fixed and Unnumbered. The setting is via ip_type command.
The ip unnumbered configuration command allows you to enable IP processing on a serial
interface without assigning it an explicit IP address. The ip unnumbered interface can "borrow" the
IP address of another interface already configured on this router, which conserves network and
address space.
5
5
.
.
1
1
2
2
.
.
3
3
.
.
8
8
L
L
i
i
s
s
t
t
You can review the WAN interface configuration via list command.
5
5
.
.
1
1
2
2
.
.
4
4
B
B
r
r
i
i
d
d
g
g
e
e
You can setup the bridge parameters in bridge command. If the product is configured as a router,
you do not want to setup the bridge parameters.
Move the cursor “ >> “ to bridge and press enter.
>>
gateway
Default gateway
static
Static bridging table
5
5
.
.
1
1
2
2
.
.
4
4
.
.
1
1
G
G
a
a
t
t
e
e
w
w
a
a
y
y
You can setup default gateway IP via gateway command.
Bridge Gateway: