User manual

Dynamix UM-SB Series User Manual V0.06
116
5
5
.
.
1
1
0
0
.
.
3
3
R
R
e
e
s
s
t
t
o
o
r
r
e
e
Move the cursor “ >> “ to restore and press enter.
------------------------------------------------------------------------
Command: utility restore <ip> <file>
Message: Please input the following information.
TFTP server IP address (ENTER for default) <192.168.0.2>: 192.168.0.150
Upgrade filename (ENTER for default) <default.bin>: backup002.bin
------------------------------------------------------------------------
Type TFTP server IP address and restore filename of system configuration.
5
5
.
.
1
1
1
1
E
E
x
x
i
i
t
t
If you want to exit the system without saving, use exit command to quit system.
------------------------------------------------------------------------
Command: exit <CR>
Message: Please input the following information.
Do you want to disconnect? (y/n):
------------------------------------------------------------------------
Press “y” to confirm the exit operation.
5
5
.
.
1
1
2
2
S
S
e
e
t
t
u
u
p
p
All of the setup parameters are located in the subdirectories of setup. Move the cursor “ >> “ to
setup and press enter.
>>
mode
Switch system operation mode
shdsl.bis
Configure SHDSL.bis parameters
wan
Configure WAN interface profile
bridge
Configure transparent bridging
vlan
stp
route
Configure virtual LAN parameters
Configure bridge STP parameters
Configure routing parameters
lan
Configure LAN interface profile
ip_share
Configure NAT/PAT parameters
firewall
ip_qos
Configure firewall profile
Configure IP QoS parameters
dhcp
Configure DHCP parameters
dns_proxy
Configure DNS proxy parameters
hostname
Configure local host name
default
Restore factory default setting